* published by the Free Software Foundation.
*/
-#include <linux/config.h>
#include <linux/module.h>
#include <linux/kernel.h>
#include <linux/device.h>
#include <asm/arch/clock.h>
#include <asm/arch/sram.h>
-#include "prcm-regs.h"
+#include "prm.h"
+
#include "memory.h"
+#include "sdrc.h"
+
+unsigned long omap2_sdrc_base;
+unsigned long omap2_sms_base;
static struct memory_timings mem_timings;
+static u32 curr_perf_level = CORE_CLK_SRC_DPLL_X2;
u32 omap2_memory_get_slow_dll_ctrl(void)
{
return mem_timings.m_type;
}
+/*
+ * Check the DLL lock state, and return tue if running in unlock mode.
+ * This is needed to compensate for the shifted DLL value in unlock mode.
+ */
+u32 omap2_dll_force_needed(void)
+{
+ /* dlla and dllb are a set */
+ u32 dll_state = sdrc_read_reg(SDRC_DLLA_CTRL);
+
+ if ((dll_state & (1 << 2)) == (1 << 2))
+ return 1;
+ else
+ return 0;
+}
+
+/*
+ * 'level' is the value to store to CM_CLKSEL2_PLL.CORE_CLK_SRC.
+ * Practical values are CORE_CLK_SRC_DPLL (for CORE_CLK = DPLL_CLK) or
+ * CORE_CLK_SRC_DPLL_X2 (for CORE_CLK = * DPLL_CLK * 2)
+ */
+u32 omap2_reprogram_sdrc(u32 level, u32 force)
+{
+ u32 dll_ctrl, m_type;
+ u32 prev = curr_perf_level;
+ unsigned long flags;
+
+ if ((curr_perf_level == level) && !force)
+ return prev;
+
+ if (level == CORE_CLK_SRC_DPLL) {
+ dll_ctrl = omap2_memory_get_slow_dll_ctrl();
+ } else if (level == CORE_CLK_SRC_DPLL_X2) {
+ dll_ctrl = omap2_memory_get_fast_dll_ctrl();
+ } else {
+ return prev;
+ }
+
+ m_type = omap2_memory_get_type();
+
+ local_irq_save(flags);
+ __raw_writel(0xffff, OMAP24XX_PRCM_VOLTSETUP);
+ omap2_sram_reprogram_sdrc(level, dll_ctrl, m_type);
+ curr_perf_level = level;
+ local_irq_restore(flags);
+
+ return prev;
+}
+
void omap2_init_memory_params(u32 force_lock_to_unlock_mode)
{
unsigned long dll_cnt;
u32 fast_dll = 0;
- mem_timings.m_type = !((SDRC_MR_0 & 0x3) == 0x1); /* DDR = 1, SDR = 0 */
+ mem_timings.m_type = !((sdrc_read_reg(SDRC_MR_0) & 0x3) == 0x1); /* DDR = 1, SDR = 0 */
/* 2422 es2.05 and beyond has a single SIP DDR instead of 2 like others.
* In the case of 2422, its ok to use CS1 instead of CS0.
mem_timings.dll_mode = M_LOCK;
if (mem_timings.base_cs == 0) {
- fast_dll = SDRC_DLLA_CTRL;
- dll_cnt = SDRC_DLLA_STATUS & 0xff00;
+ fast_dll = sdrc_read_reg(SDRC_DLLA_CTRL);
+ dll_cnt = sdrc_read_reg(SDRC_DLLA_STATUS) & 0xff00;
} else {
- fast_dll = SDRC_DLLB_CTRL;
- dll_cnt = SDRC_DLLB_STATUS & 0xff00;
+ fast_dll = sdrc_read_reg(SDRC_DLLB_CTRL);
+ dll_cnt = sdrc_read_reg(SDRC_DLLB_STATUS) & 0xff00;
}
if (force_lock_to_unlock_mode) {
fast_dll &= ~0xff00;
/* 90 degree phase for anything below 133Mhz + disable DLL filter */
mem_timings.slow_dll_ctrl |= ((1 << 1) | (3 << 8));
}
+
+/* turn on smart idle modes for SDRAM scheduler and controller */
+void __init omap2_init_memory(void)
+{
+ u32 l;
+
+ l = sms_read_reg(SMS_SYSCONFIG);
+ l &= ~(0x3 << 3);
+ l |= (0x2 << 3);
+ sms_write_reg(l, SMS_SYSCONFIG);
+
+ l = sdrc_read_reg(SDRC_SYSCONFIG);
+ l &= ~(0x3 << 3);
+ l |= (0x2 << 3);
+ sdrc_write_reg(l, SDRC_SYSCONFIG);
+}