#include <linux/platform_device.h>
#include <linux/errno.h>
#include <linux/workqueue.h>
+#include <linux/i2c.h>
#include <linux/mtd/mtd.h>
#include <linux/mtd/nand.h>
#include <linux/mtd/partitions.h>
#include <linux/input.h>
+#include <linux/i2c/tps65010.h>
#include <asm/setup.h>
#include <asm/page.h>
#include <asm/hardware.h>
+#include <asm/gpio.h>
+
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <asm/mach/flash.h>
#include <asm/mach/map.h>
-#include <asm/arch/gpio.h>
#include <asm/arch/gpioexpander.h>
#include <asm/arch/irqs.h>
#include <asm/arch/mux.h>
[1] = {
.start = OMAP_GPIO_IRQ(40),
.end = OMAP_GPIO_IRQ(40),
- .flags = IORESOURCE_IRQ,
+ .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_LOWEDGE,
},
};
{ OMAP_TAG_LCD, &h3_lcd_config },
};
+static struct i2c_board_info __initdata h3_i2c_board_info[] = {
+ {
+ I2C_BOARD_INFO("tps65010", 0x48),
+ .type = "tps65013",
+ /* .irq = OMAP_GPIO_IRQ(??), */
+ },
+ /* TODO when driver support is ready:
+ * - isp1301 OTG transceiver
+ * - optional ov9640 camera sensor at 0x30
+ * - ...
+ */
+};
+
#define H3_NAND_RB_GPIO_PIN 10
static int nand_dev_ready(struct nand_platform_data *data)
omap_board_config = h3_config;
omap_board_config_size = ARRAY_SIZE(h3_config);
omap_serial_init();
+
+ /* FIXME setup irq for tps65013 chip */
+ i2c_register_board_info(1, h3_i2c_board_info,
+ ARRAY_SIZE(h3_i2c_board_info));
}
static void __init h3_init_smc91x(void)
omap1_map_common_io();
}
+#ifdef CONFIG_TPS65010
+static int __init h3_tps_init(void)
+{
+ if (!machine_is_omap_h3())
+ return 0;
+
+ /* gpio4 for SD, gpio3 for VDD_DSP */
+ /* FIXME send power to DSP iff it's configured */
+
+ /* Enable LOW_PWR */
+ tps65013_set_low_pwr(ON);
+
+ return 0;
+}
+fs_initcall(h3_tps_init);
+#endif
+
MACHINE_START(OMAP_H3, "TI OMAP1710 H3 board")
/* Maintainer: Texas Instruments, Inc. */
.phys_io = 0xfff00000,