If the thread is needed for writing the image to storage, you should
instead set the PF_NOFREEZE process flag when creating the thread (and
-be very carefull).
+be very careful).
-Q: What is the difference between between "platform", "shutdown" and
+Q: What is the difference between "platform", "shutdown" and
"firmware" in /sys/power/disk?
A:
Q: I do not understand why you have such strong objections to idea of
selective suspend.
-A: Do selective suspend during runtime power managment, that's okay. But
-its useless for suspend-to-disk. (And I do not see how you could use
+A: Do selective suspend during runtime power management, that's okay. But
+it's useless for suspend-to-disk. (And I do not see how you could use
it for suspend-to-ram, I hope you do not want that).
Lets see, so you suggest to
For devices like disk it does matter, you do not want to spindown for
FREEZE.
-Q: After resuming, system is paging heavilly, leading to very bad interactivity.
+Q: After resuming, system is paging heavily, leading to very bad interactivity.
A: Try running
A: If you want to see any non-error kernel messages on the virtual
terminal the kernel switches to during suspend, you have to set the
-kernel console loglevel to at least 5, for example by doing
-
- echo 5 > /proc/sys/kernel/printk
+kernel console loglevel to at least 4 (KERN_WARNING), for example by
+doing
+
+ # save the old loglevel
+ read LOGLEVEL DUMMY < /proc/sys/kernel/printk
+ # set the loglevel so we see the progress bar.
+ # if the level is higher than needed, we leave it alone.
+ if [ $LOGLEVEL -lt 5 ]; then
+ echo 5 > /proc/sys/kernel/printk
+ fi
+
+ IMG_SZ=0
+ read IMG_SZ < /sys/power/image_size
+ echo -n disk > /sys/power/state
+ RET=$?
+ #
+ # the logic here is:
+ # if image_size > 0 (without kernel support, IMG_SZ will be zero),
+ # then try again with image_size set to zero.
+ if [ $RET -ne 0 -a $IMG_SZ -ne 0 ]; then # try again with minimal image size
+ echo 0 > /sys/power/image_size
+ echo -n disk > /sys/power/state
+ RET=$?
+ fi
+
+ # restore previous loglevel
+ echo $LOGLEVEL > /proc/sys/kernel/printk
+ exit $RET
Q: Is this true that if I have a mounted filesystem on a USB device and
I suspend to disk, I can lose data unless the filesystem has been mounted
Firewire, CompactFlash, MMC, external SATA, or even IDE hotplug bays)
before suspending; then remount them after resuming.
+Q: I upgraded the kernel from 2.6.15 to 2.6.16. Both kernels were
+compiled with the similar configuration files. Anyway I found that
+suspend to disk (and resume) is much slower on 2.6.16 compared to
+2.6.15. Any idea for why that might happen or how can I speed it up?
+
+A: This is because the size of the suspend image is now greater than
+for 2.6.15 (by saving more data we can get more responsive system
+after resume).
+
+There's the /sys/power/image_size knob that controls the size of the
+image. If you set it to 0 (eg. by echo 0 > /sys/power/image_size as
+root), the 2.6.15 behavior should be restored. If it is still too
+slow, take a look at suspend.sf.net -- userland suspend is faster and
+supports LZF compression to speed it up further.