F-RTO is an enhanced recovery algorithm for TCP retransmission
timeouts. It is particularly beneficial in wireless environments
where packet loss is typically due to random radio interference
- rather than intermediate router congestion. FRTO is sender-side
+ rather than intermediate router congestion. F-RTO is sender-side
only modification. Therefore it does not require any support from
the peer, but in a typical case, however, where wireless link is
the local access link and most of the data flows downlink, the
- faraway servers should have FRTO enabled to take advantage of it.
+ faraway servers should have F-RTO enabled to take advantage of it.
If set to 1, basic version is enabled. 2 enables SACK enhanced
F-RTO if flow uses SACK. The basic version can be used also when
- SACK is in use though scenario(s) with it exists where FRTO
+ SACK is in use though scenario(s) with it exists where F-RTO
interacts badly with the packet counting of the SACK enabled TCP
flow.
and CONFIG_NET_DMA is enabled.
Default: 4096
+UDP variables:
+
+udp_mem - vector of 3 INTEGERs: min, pressure, max
+ Number of pages allowed for queueing by all UDP sockets.
+
+ min: Below this number of pages UDP is not bothered about its
+ memory appetite. When amount of memory allocated by UDP exceeds
+ this number, UDP starts to moderate memory usage.
+
+ pressure: This value was introduced to follow format of tcp_mem.
+
+ max: Number of pages allowed for queueing by all UDP sockets.
+
+ Default is calculated at boot time from amount of available memory.
+
+udp_rmem_min - INTEGER
+ Minimal size of receive buffer used by UDP sockets in moderation.
+ Each UDP socket is able to use the size for receiving data, even if
+ total pages of UDP sockets exceed udp_mem pressure. The unit is byte.
+ Default: 4096
+
+udp_wmem_min - INTEGER
+ Minimal size of send buffer used by UDP sockets in moderation.
+ Each UDP socket is able to use the size for sending data, even if
+ total pages of UDP sockets exceed udp_mem pressure. The unit is byte.
+ Default: 4096
+
CIPSOv4 Variables:
cipso_cache_enable - BOOLEAN