Manually" section, below.
NOTE: It has been observed that some Red Hat supplied kernels
-are apparently unable to rename modules at load time (the "-obonding1"
+are apparently unable to rename modules at load time (the "-o bond1"
part). Attempts to pass that option to modprobe will produce an
"Operation not permitted" error. This has been reported on some
Fedora Core kernels, and has been seen on RHEL 4 as well. On kernels
its options. In that case, the second options line can be substituted
as follows:
-install bonding1 /sbin/modprobe bonding -obond1 mode=balance-alb miimon=50
+install bond1 /sbin/modprobe --ignore-install bonding -o bond1 \
+ mode=balance-alb miimon=50
This may be repeated any number of times, specifying a new and
unique name in place of bond1 for each subsequent instance.
collisions:0 txqueuelen:0
eth0 Link encap:Ethernet HWaddr 00:C0:F0:1F:37:B4
- inet addr:XXX.XXX.XXX.YYY Bcast:XXX.XXX.XXX.255 Mask:255.255.252.0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3573025 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643167 errors:1 dropped:0 overruns:1 carrier:0
Interrupt:10 Base address:0x1080
eth1 Link encap:Ethernet HWaddr 00:C0:F0:1F:37:B4
- inet addr:XXX.XXX.XXX.YYY Bcast:XXX.XXX.XXX.255 Mask:255.255.252.0
UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1
RX packets:3651769 errors:0 dropped:0 overruns:0 frame:0
TX packets:1643480 errors:0 dropped:0 overruns:0 carrier:0