This can be written only while the array is being assembled, not
after it is started.
+ new_dev
+ This file can be written but not read. The value written should
+ be a block device number as major:minor. e.g. 8:0
+ This will cause that device to be attached to the array, if it is
+ available. It will then appear at md/dev-XXX (depending on the
+ name of the device) and further configuration is then possible.
+
+ sync_speed_min
+ sync_speed_max
+ This are similar to /proc/sys/dev/raid/speed_limit_{min,max}
+ however they only apply to the particular array.
+ If no value has been written to these, of if the word 'system'
+ is written, then the system-wide value is used. If a value,
+ in kibibytes-per-second is written, then it is used.
+ When the files are read, they show the currently active value
+ followed by "(local)" or "(system)" depending on whether it is
+ a locally set or system-wide value.
+
+ sync_completed
+ This shows the number of sectors that have been completed of
+ whatever the current sync_action is, followed by the number of
+ sectors in total that could need to be processed. The two
+ numbers are separated by a '/' thus effectively showing one
+ value, a fraction of the process that is complete.
+
+ sync_speed
+ This shows the current actual speed, in K/sec, of the current
+ sync_action. It is averaged over the last 30 seconds.
+
+
As component devices are added to an md array, they appear in the 'md'
directory as new directories named
dev-XXX
it currently fills. This can only be set while assembling an
array. A device for which this is set is assumed to be working.
+ offset
+ This gives the location in the device (in sectors from the
+ start) where data from the array will be stored. Any part of
+ the device before this offset us not touched, unless it is
+ used for storing metadata (Formats 1.1 and 1.2).
+
+ size
+ The amount of the device, after the offset, that can be used
+ for storage of data. This will normally be the same as the
+ component_size. This can be written while assembling an
+ array. If a value less than the current component_size is
+ written, component_size will be reduced to this value.
+
An active md device will also contain and entry for each active device
in the array. These are named