eata= [HW,SCSI]
edd= [EDD]
- Format: {"of[f]" | "sk[ipmbr]"}
- See comment in arch/i386/boot/edd.S
+ Format: {"off" | "on" | "skip[mbr]"}
eisa_irq_edge= [PARISC,HW]
See header of drivers/parisc/eisa.c.
nr_uarts= [SERIAL] maximum number of UARTs to be registered.
+ olpc_ec_timeout= [OLPC] ms delay when issuing EC commands
+ Rather than timing out after 20 ms if an EC
+ command is not properly ACKed, override the length
+ of the timeout. We have interrupts disabled while
+ waiting for the ACK, so if this is set too high
+ interrupts *may* be lost!
+
opl3= [HW,OSS]
Format: <io>
This is normally done in pci_enable_device(),
so this option is a temporary workaround
for broken drivers that don't call it.
+ skip_isa_align [X86] do not align io start addr, so can
+ handle more pci cards
firmware [ARM] Do not re-enumerate the bus but instead
just use the configuration from the
bootloader. This is currently used on