***
*** The CMD640 is also used on some Vesa Local Bus (VLB) cards, and is *NOT*
*** automatically detected by Linux. For safe, reliable operation with such
-*** interfaces, one *MUST* use the "ide0=cmd640_vlb" kernel option.
+*** interfaces, one *MUST* use the "cmd640.probe_vlb" kernel option.
***
*** Use of the "serialize" option is no longer necessary.
and quite likely to cause trouble with
older/odd IDE drives.
- "hdx=swapdata" : when the drive is a disk, byte swap all data
-
- "hdx=bswap" : same as above..........
+ "hdx=nodma" : disallow DMA
"hdx=scsi" : the return of the ide-scsi flag, this is useful for
allowing ide-floppy, ide-tape, and ide-cdrom|writers
"idex=four" : four drives on idex and ide(x^1) share same ports
"idex=reset" : reset interface after probe
-
- "idex=dma" : automatically configure/use DMA if possible.
"idex=ata66" : informs the interface that it has an 80c cable
for chipsets that are ATA-66 capable, but the
"ide=reverse" : formerly called to pci sub-system, but now local.
- "ide=nodma" : disable DMA globally for the IDE subsystem.
-
The following are valid ONLY on ide0, which usually corresponds
to the first ATA interface found on the particular host, and the defaults for
the base,ctl ports must not be altered.
- "ide0=dtc2278" : probe/support DTC2278 interface
- "ide0=ht6560b" : probe/support HT6560B interface
- "ide0=cmd640_vlb" : *REQUIRED* for VLB cards with the CMD640 chip
- (not for PCI -- automatically detected)
- "ide0=qd65xx" : probe/support qd65xx interface
- "ide0=ali14xx" : probe/support ali14xx chipsets (ALI M1439/M1443/M1445)
- "ide0=umc8672" : probe/support umc8672 chipsets
-
"ide=doubler" : probe/support IDE doublers on Amiga
There may be more options than shown -- use the source, Luke!
Everything else is rejected with a "BAD OPTION" message.
+For legacy IDE VLB host drivers (ali14xx/dtc2278/ht6560b/qd65xx/umc8672)
+you need to explicitly enable probing by using "probe" kernel parameter,
+i.e. to enable probing for ALI M14xx chipsets (ali14xx host driver) use:
+
+* "ali14xx.probe" boot option when ali14xx driver is built-in the kernel
+
+* "probe" module parameter when ali14xx driver is compiled as module
+ ("modprobe ali14xx probe")
+
+Also for legacy CMD640 host driver (cmd640) you need to use "probe_vlb"
+kernel paremeter to enable probing for VLB version of the chipset (PCI ones
+are detected automatically).
+
================================================================================
IDE ATAPI streaming tape driver