+ /* If we have 5702/03 A1 or A2 on certain ICH chipsets,
+ * we need to disable memory and use config. cycles
+ * only to access all registers. The 5702/03 chips
+ * can mistakenly decode the special cycles from the
+ * ICH chipsets as memory write cycles, causing corruption
+ * of register and memory space. Only certain ICH bridges
+ * will drive special cycles with non-zero data during the
+ * address phase which can fall within the 5703's address
+ * range. This is not an ICH bug as the PCI spec allows
+ * non-zero address during special cycles. However, only
+ * these ICH bridges are known to drive non-zero addresses
+ * during special cycles.
+ *
+ * Since special cycles do not cross PCI bridges, we only
+ * enable this workaround if the 5703 is on the secondary
+ * bus of these ICH bridges.
+ */
+ if ((tp->pci_chip_rev_id == CHIPREV_ID_5703_A1) ||
+ (tp->pci_chip_rev_id == CHIPREV_ID_5703_A2)) {
+ static struct tg3_dev_id {
+ u32 vendor;
+ u32 device;
+ u32 rev;
+ } ich_chipsets[] = {
+ { PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801AA_8,
+ PCI_ANY_ID },
+ { PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801AB_8,
+ PCI_ANY_ID },
+ { PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801BA_11,
+ 0xa },
+ { PCI_VENDOR_ID_INTEL, PCI_DEVICE_ID_INTEL_82801BA_6,
+ PCI_ANY_ID },
+ { },
+ };
+ struct tg3_dev_id *pci_id = &ich_chipsets[0];
+ struct pci_dev *bridge = NULL;
+
+ while (pci_id->vendor != 0) {
+ bridge = pci_get_device(pci_id->vendor, pci_id->device,
+ bridge);
+ if (!bridge) {
+ pci_id++;
+ continue;
+ }
+ if (pci_id->rev != PCI_ANY_ID) {
+ u8 rev;
+
+ pci_read_config_byte(bridge, PCI_REVISION_ID,
+ &rev);
+ if (rev > pci_id->rev)
+ continue;
+ }
+ if (bridge->subordinate &&
+ (bridge->subordinate->number ==
+ tp->pdev->bus->number)) {
+
+ tp->tg3_flags2 |= TG3_FLG2_ICH_WORKAROUND;
+ pci_dev_put(bridge);
+ break;
+ }
+ }
+ }
+