-/* The status fifo address definition below is used as a base for each
- * node, which a chunk seperately assigned to each unit directory in the
- * node. For example, 0xfffe00000000ULL is used for the first sbp2 device
- * detected on node 0, 0xfffe00000020ULL for the next sbp2 device on node
- * 0, and so on.
- *
- * Note: We could use a single status fifo address for all sbp2 devices,
- * and figure out which sbp2 device the status belongs to by looking at
- * the source node id of the status write... but, using separate addresses
- * for each sbp2 unit directory allows for better code and the ability to
- * support multiple luns within a single 1394 node.
- *
- * Also note that we choose the address range below as it is a region
- * specified for write posting, where the ohci controller will
- * automatically send an ack_complete when the status is written by the
- * sbp2 device... saving a split transaction. =)
- */
-#define SBP2_STATUS_FIFO_ADDRESS 0xfffe00000000ULL
-#define SBP2_STATUS_FIFO_ADDRESS_HI 0xfffe
-#define SBP2_STATUS_FIFO_ADDRESS_LO 0x0
-
-#define SBP2_STATUS_FIFO_ENTRY_TO_OFFSET(entry) ((entry) << 5)
-#define SBP2_STATUS_FIFO_OFFSET_TO_ENTRY(offset) ((offset) >> 5)
-