+fail_over_mac
+
+ Specifies whether active-backup mode should set all slaves to
+ the same MAC address (the traditional behavior), or, when
+ enabled, change the bond's MAC address when changing the
+ active interface (i.e., fail over the MAC address itself).
+
+ Fail over MAC is useful for devices that cannot ever alter
+ their MAC address, or for devices that refuse incoming
+ broadcasts with their own source MAC (which interferes with
+ the ARP monitor).
+
+ The down side of fail over MAC is that every device on the
+ network must be updated via gratuitous ARP, vs. just updating
+ a switch or set of switches (which often takes place for any
+ traffic, not just ARP traffic, if the switch snoops incoming
+ traffic to update its tables) for the traditional method. If
+ the gratuitous ARP is lost, communication may be disrupted.
+
+ When fail over MAC is used in conjuction with the mii monitor,
+ devices which assert link up prior to being able to actually
+ transmit and receive are particularly susecptible to loss of
+ the gratuitous ARP, and an appropriate updelay setting may be
+ required.
+
+ A value of 0 disables fail over MAC, and is the default. A
+ value of 1 enables fail over MAC. This option is enabled
+ automatically if the first slave added cannot change its MAC
+ address. This option may be modified via sysfs only when no
+ slaves are present in the bond.
+
+ This option was added in bonding version 3.2.0.
+