+ sync_speed_min
+ sync_speed_max
+ This are similar to /proc/sys/dev/raid/speed_limit_{min,max}
+ however they only apply to the particular array.
+ If no value has been written to these, of if the word 'system'
+ is written, then the system-wide value is used. If a value,
+ in kibibytes-per-second is written, then it is used.
+ When the files are read, they show the currently active value
+ followed by "(local)" or "(system)" depending on whether it is
+ a locally set or system-wide value.
+
+ sync_completed
+ This shows the number of sectors that have been completed of
+ whatever the current sync_action is, followed by the number of
+ sectors in total that could need to be processed. The two
+ numbers are separated by a '/' thus effectively showing one
+ value, a fraction of the process that is complete.
+ A 'select' on this attribute will return when resync completes,
+ when it reaches the current sync_max (below) and possibly at
+ other times.
+
+ sync_max
+ This is a number of sectors at which point a resync/recovery
+ process will pause. When a resync is active, the value can
+ only ever be increased, never decreased. The value of 'max'
+ effectively disables the limit.
+
+
+ sync_speed
+ This shows the current actual speed, in K/sec, of the current
+ sync_action. It is averaged over the last 30 seconds.
+
+ suspend_lo
+ suspend_hi
+ The two values, given as numbers of sectors, indicate a range
+ within the array where IO will be blocked. This is currently
+ only supported for raid4/5/6.
+
+