+ Some raid level (RAID1) allow this value to be set while the
+ array is active. This will reconfigure the array. Otherwise
+ it can only be set while assembling an array.
+
+ chunk_size
+ This is the size if bytes for 'chunks' and is only relevant to
+ raid levels that involve striping (1,4,5,6,10). The address space
+ of the array is conceptually divided into chunks and consecutive
+ chunks are striped onto neighbouring devices.
+ The size should be atleast PAGE_SIZE (4k) and should be a power
+ of 2. This can only be set while assembling an array
+
+ component_size
+ For arrays with data redundancy (i.e. not raid0, linear, faulty,
+ multipath), all components must be the same size - or at least
+ there must a size that they all provide space for. This is a key
+ part or the geometry of the array. It is measured in sectors
+ and can be read from here. Writing to this value may resize
+ the array if the personality supports it (raid1, raid5, raid6),
+ and if the component drives are large enough.
+
+ metadata_version
+ This indicates the format that is being used to record metadata
+ about the array. It can be 0.90 (traditional format), 1.0, 1.1,
+ 1.2 (newer format in varying locations) or "none" indicating that
+ the kernel isn't managing metadata at all.
+
+ level
+ The raid 'level' for this array. The name will often (but not
+ always) be the same as the name of the module that implements the
+ level. To be auto-loaded the module must have an alias
+ md-$LEVEL e.g. md-raid5
+ This can be written only while the array is being assembled, not
+ after it is started.
+
+ new_dev
+ This file can be written but not read. The value written should
+ be a block device number as major:minor. e.g. 8:0
+ This will cause that device to be attached to the array, if it is
+ available. It will then appear at md/dev-XXX (depending on the
+ name of the device) and further configuration is then possible.
+
+ sync_speed_min
+ sync_speed_max
+ This are similar to /proc/sys/dev/raid/speed_limit_{min,max}
+ however they only apply to the particular array.
+ If no value has been written to these, of if the word 'system'
+ is written, then the system-wide value is used. If a value,
+ in kibibytes-per-second is written, then it is used.
+ When the files are read, they show the currently active value
+ followed by "(local)" or "(system)" depending on whether it is
+ a locally set or system-wide value.
+
+ sync_completed
+ This shows the number of sectors that have been completed of
+ whatever the current sync_action is, followed by the number of
+ sectors in total that could need to be processed. The two
+ numbers are separated by a '/' thus effectively showing one
+ value, a fraction of the process that is complete.
+
+ sync_speed
+ This shows the current actual speed, in K/sec, of the current
+ sync_action. It is averaged over the last 30 seconds.
+