2 tristate "Generic IEEE 802.11 Networking Stack (mac80211)"
3 depends on EXPERIMENTAL
13 This option enables the hardware independent IEEE 802.11
16 config MAC80211_RCSIMPLE
17 bool "'simple' rate control algorithm" if EMBEDDED
21 This option allows you to turn off the 'simple' rate
22 control algorithm in mac80211. If you do turn it off,
23 you absolutely need another rate control algorithm.
25 Say Y unless you know you will have another algorithm
29 bool "'PID' rate control algorithm" if EMBEDDED
33 This option enables a TX rate control algorithm for
34 mac80211 that uses a PID controller to select the TX
37 Say Y unless you're sure you want to use a different
38 rate control algorithm.
41 bool "Enable LED triggers"
42 depends on MAC80211 && LEDS_TRIGGERS
44 This option enables a few LED triggers for different
45 packet receive/transmit events.
47 config MAC80211_DEBUGFS
48 bool "Export mac80211 internals in DebugFS"
49 depends on MAC80211 && DEBUG_FS
51 Select this to see extensive information about
52 the internal state of mac80211 in debugfs.
54 Say N unless you know you need this.
57 bool "Enable debugging output"
60 This option will enable debug tracing output for the
61 ieee80211 network stack.
63 If you are not trying to debug or develop the ieee80211
64 subsystem, you most likely want to say N here.
66 config MAC80211_HT_DEBUG
67 bool "Enable HT debugging output"
68 depends on MAC80211_DEBUG
70 This option enables 802.11n High Throughput features
73 If you are not trying to debug of develop the ieee80211
74 subsystem, you most likely want to say N here.
76 config MAC80211_VERBOSE_DEBUG
77 bool "Verbose debugging output"
78 depends on MAC80211_DEBUG
80 config MAC80211_LOWTX_FRAME_DUMP
81 bool "Debug frame dumping"
82 depends on MAC80211_DEBUG
84 Selecting this option will cause the stack to
85 print a message for each frame that is handed
86 to the lowlevel driver for transmission. This
87 message includes all MAC addresses and the
90 If unsure, say N and insert the debugging code
91 you require into the driver you are debugging.
95 depends on MAC80211_DEBUG
97 config MAC80211_DEBUG_COUNTERS
98 bool "Extra statistics for TX/RX debugging"
99 depends on MAC80211_DEBUG
101 config MAC80211_IBSS_DEBUG
102 bool "Support for IBSS testing"
103 depends on MAC80211_DEBUG
105 Say Y here if you intend to debug the IBSS code.
107 config MAC80211_VERBOSE_PS_DEBUG
108 bool "Verbose powersave mode debugging"
109 depends on MAC80211_DEBUG
111 Say Y here to print out verbose powersave