2 # Touchscreen driver configuration
4 menuconfig INPUT_TOUCHSCREEN
7 Say Y here, and a list of supported touchscreens will be displayed.
8 This option doesn't affect the kernel.
14 config TOUCHSCREEN_ADS7846
15 tristate "ADS7846/TSC2046 and ADS7843 based touchscreens"
17 depends on HWMON = n || HWMON
19 Say Y here if you have a touchscreen interface using the
20 ADS7846/TSC2046 or ADS7843 controller, and your board-specific
21 setup code includes that in its table of SPI devices.
23 If HWMON is selected, and the driver is told the reference voltage
24 on your board, you will also get hwmon interfaces for the voltage
25 (and on ads7846/tsc2046, temperature) sensors of this chip.
27 If unsure, say N (but it's safe to say "Y").
29 To compile this driver as a module, choose M here: the
30 module will be called ads7846.
32 config TOUCHSCREEN_BITSY
33 tristate "Compaq iPAQ H3600 (Bitsy) touchscreen"
34 depends on SA1100_BITSY
37 Say Y here if you have the h3600 (Bitsy) touchscreen.
41 To compile this driver as a module, choose M here: the
42 module will be called h3600_ts_input.
44 config TOUCHSCREEN_CORGI
45 tristate "SharpSL (Corgi and Spitz series) touchscreen driver"
46 depends on PXA_SHARPSL
49 Say Y here to enable the driver for the touchscreen on the
50 Sharp SL-C7xx and SL-Cxx00 series of PDAs.
54 To compile this driver as a module, choose M here: the
55 module will be called corgi_ts.
57 config TOUCHSCREEN_FUJITSU
58 tristate "Fujitsu serial touchscreen"
61 Say Y here if you have the Fujitsu touchscreen (such as one
62 installed in Lifebook P series laptop) connected to your
67 To compile this driver as a module, choose M here: the
68 module will be called fujitsu-ts.
70 config TOUCHSCREEN_GUNZE
71 tristate "Gunze AHL-51S touchscreen"
74 Say Y here if you have the Gunze AHL-51 touchscreen connected to
79 To compile this driver as a module, choose M here: the
80 module will be called gunze.
82 config TOUCHSCREEN_ELO
83 tristate "Elo serial touchscreens"
86 Say Y here if you have an Elo serial touchscreen connected to
91 To compile this driver as a module, choose M here: the
92 module will be called elo.
94 config TOUCHSCREEN_MTOUCH
95 tristate "MicroTouch serial touchscreens"
98 Say Y here if you have a MicroTouch (3M) serial touchscreen connected to
103 To compile this driver as a module, choose M here: the
104 module will be called mtouch.
106 config TOUCHSCREEN_MK712
107 tristate "ICS MicroClock MK712 touchscreen"
109 Say Y here if you have the ICS MicroClock MK712 touchscreen
110 controller chip in your system.
114 To compile this driver as a module, choose M here: the
115 module will be called mk712.
117 config TOUCHSCREEN_HP600
118 tristate "HP Jornada 6xx touchscreen"
119 depends on SH_HP6XX && SH_ADC
121 Say Y here if you have a HP Jornada 620/660/680/690 and want to
122 support the built-in touchscreen.
124 To compile this driver as a module, choose M here: the
125 module will be called hp680_ts_input.
127 config TOUCHSCREEN_HP7XX
128 tristate "HP Jornada 7xx touchscreen"
129 depends on SA1100_JORNADA720_SSP
131 Say Y here if you have a HP Jornada 710/720/728 and want
132 to support the built-in touchscreen.
134 To compile this driver as a module, choose M here: the
135 module will be called jornada720_ts.
137 config TOUCHSCREEN_HTCPEN
138 tristate "HTC Shift X9500 touchscreen"
141 Say Y here if you have an HTC Shift UMPC also known as HTC X9500
142 Clio / Shangrila and want to support the built-in touchscreen.
146 To compile this driver as a module, choose M here: the
147 module will be called htcpen.
149 config TOUCHSCREEN_PENMOUNT
150 tristate "Penmount serial touchscreen"
153 Say Y here if you have a Penmount serial touchscreen connected to
158 To compile this driver as a module, choose M here: the
159 module will be called penmount.
161 config TOUCHSCREEN_MIGOR
162 tristate "Renesas MIGO-R touchscreen"
163 depends on SH_MIGOR && I2C
165 Say Y here to enable MIGO-R touchscreen support.
169 To compile this driver as a module, choose M here: the
170 module will be called migor_ts.
172 config TOUCHSCREEN_TOUCHRIGHT
173 tristate "Touchright serial touchscreen"
176 Say Y here if you have a Touchright serial touchscreen connected to
181 To compile this driver as a module, choose M here: the
182 module will be called touchright.
184 config TOUCHSCREEN_TOUCHWIN
185 tristate "Touchwin serial touchscreen"
188 Say Y here if you have a Touchwin serial touchscreen connected to
193 To compile this driver as a module, choose M here: the
194 module will be called touchwin.
196 config TOUCHSCREEN_UCB1400
197 tristate "Philips UCB1400 touchscreen"
200 This enables support for the Philips UCB1400 touchscreen interface.
201 The UCB1400 is an AC97 audio codec. The touchscreen interface
202 will be initialized only after the ALSA subsystem has been
203 brought up and the UCB1400 detected. You therefore have to
204 configure ALSA support as well (either built-in or modular,
205 independently of whether this driver is itself built-in or
206 modular) for this driver to work.
208 To compile this driver as a module, choose M here: the
209 module will be called ucb1400_ts.
211 config TOUCHSCREEN_WM97XX
212 tristate "Support for WM97xx AC97 touchscreen controllers"
215 Say Y here if you have a Wolfson Microelectronics WM97xx
216 touchscreen connected to your system. Note that this option
217 only enables core driver, you will also need to select
218 support for appropriate chip below.
222 To compile this driver as a module, choose M here: the
223 module will be called wm97xx-ts.
225 config TOUCHSCREEN_WM9705
226 bool "WM9705 Touchscreen interface support"
227 depends on TOUCHSCREEN_WM97XX
229 Say Y here if you have a Wolfson Microelectronics WM9705
230 touchscreen controller connected to your system.
234 config TOUCHSCREEN_WM9712
235 bool "WM9712 Touchscreen interface support"
236 depends on TOUCHSCREEN_WM97XX
238 Say Y here if you have a Wolfson Microelectronics WM9712
239 touchscreen controller connected to your system.
243 config TOUCHSCREEN_WM9713
244 bool "WM9713 Touchscreen interface support"
245 depends on TOUCHSCREEN_WM97XX
247 Say Y here if you have a Wolfson Microelectronics WM9713 touchscreen
248 controller connected to your system.
252 config TOUCHSCREEN_WM97XX_MAINSTONE
253 tristate "WM97xx Mainstone accelerated touch"
254 depends on TOUCHSCREEN_WM97XX && ARCH_PXA
256 Say Y here for support for streaming mode with WM97xx touchscreens
257 on Mainstone systems.
261 To compile this driver as a module, choose M here: the
262 module will be called mainstone-wm97xx.
264 config TOUCHSCREEN_USB_COMPOSITE
265 tristate "USB Touchscreen Driver"
266 depends on USB_ARCH_HAS_HCD
269 USB Touchscreen driver for:
270 - eGalax Touchkit USB (also includes eTurboTouch CT-410/510/700)
271 - PanJit TouchSet USB
272 - 3M MicroTouch USB (EX II series)
274 - some other eTurboTouch
277 - IRTOUCHSYSTEMS/UNITOP
279 - GoTop Super_Q2/GogoPen/PenPower tablets
281 Have a look at <http://linux.chapter7.ch/touchkit/> for
282 a usage description and the required user-space stuff.
284 To compile this driver as a module, choose M here: the
285 module will be called usbtouchscreen.
287 config TOUCHSCREEN_USB_EGALAX
289 bool "eGalax, eTurboTouch CT-410/510/700 device support" if EMBEDDED
290 depends on TOUCHSCREEN_USB_COMPOSITE
292 config TOUCHSCREEN_USB_PANJIT
294 bool "PanJit device support" if EMBEDDED
295 depends on TOUCHSCREEN_USB_COMPOSITE
297 config TOUCHSCREEN_USB_3M
299 bool "3M/Microtouch EX II series device support" if EMBEDDED
300 depends on TOUCHSCREEN_USB_COMPOSITE
302 config TOUCHSCREEN_USB_ITM
304 bool "ITM device support" if EMBEDDED
305 depends on TOUCHSCREEN_USB_COMPOSITE
307 config TOUCHSCREEN_USB_ETURBO
309 bool "eTurboTouch (non-eGalax compatible) device support" if EMBEDDED
310 depends on TOUCHSCREEN_USB_COMPOSITE
312 config TOUCHSCREEN_USB_GUNZE
314 bool "Gunze AHL61 device support" if EMBEDDED
315 depends on TOUCHSCREEN_USB_COMPOSITE
317 config TOUCHSCREEN_USB_DMC_TSC10
319 bool "DMC TSC-10/25 device support" if EMBEDDED
320 depends on TOUCHSCREEN_USB_COMPOSITE
322 config TOUCHSCREEN_USB_IRTOUCH
324 bool "IRTOUCHSYSTEMS/UNITOP device support" if EMBEDDED
325 depends on TOUCHSCREEN_USB_COMPOSITE
327 config TOUCHSCREEN_USB_IDEALTEK
329 bool "IdealTEK URTC1000 device support" if EMBEDDED
330 depends on TOUCHSCREEN_USB_COMPOSITE
332 config TOUCHSCREEN_USB_GENERAL_TOUCH
334 bool "GeneralTouch Touchscreen device support" if EMBEDDED
335 depends on TOUCHSCREEN_USB_COMPOSITE
337 config TOUCHSCREEN_USB_GOTOP
339 bool "GoTop Super_Q2/GogoPen/PenPower tablet device support" if EMBEDDED
340 depends on TOUCHSCREEN_USB_COMPOSITE